Edwards-signaling FSRZI-A-SA Remote Zone Indicators Manuel d'utilisateur télécharger pdf

FSRZI-A(-SA) Remote Zone Indicators

Installation Sheet

Description

The FSRZI-A and FSRZI-SA are remote zone indicators for

F-series fire alarm control panels. The FSRZI-A provides five

red LEDs for indicating alarm zones. The FSRZI-SA provides

five bi-color LEDs (red for alarm zones; yellow for supervisory

and monitor zones). Configuration jumpers determine which

zones are indicated.

FSRZI-A and FSRZI-SA remote zone indicators include a

cover plate for installation in a standard, single-gang electrical

box. You can install one or two FSRZI-A and FSRZI-SA remote

zone indicators (with or without an FSRSI remote system

indicator) in an approved 2-, 3-, or 4-gang electrical box. Cover

plates for 2-, 3-, and 4-gang electrical boxes (model numbers

FSAT2, FSAT3, and FSAT4) are ordered separately.

A paper insert is provided for creating custom LED labels.

FSRZI-A and FSRZI-SA remote zone indicators are configured

using the jumpers described in the tables below.

Table 1: Group selection jumper

J5 Description

ON Selects peripheral group 1

OFF Selects peripheral group 2

Note: Only two remote zone indicators are allowed per peripheral

group.

Table 2: Zone selection jumpers

J4 J3 J2 Description

ON OFF OFF LEDs used to indicate zones 1 to 5

(IDC 1 to IDC 5 on the control panel)

OFF ON OFF LEDs used to indicate zones 6 to 10

(IDC 6 to IDC 10 on the control panel)

OFF OFF ON Not used

Note: Install a jumper on J3 only when connected to a 10-zone control

panel.

Installation

Caution: Make sure all power is disconnected from the panel

before installing. Observe static-sensitive handling practices.

For more information, refer to the technical reference manual

listed inside the control panel door.

To install the remote zone indicator:

1. Configure the jumpers as described in Table 1 and

Table 2.

2. Verify that all field wiring is free of opens, shorts, and

ground faults.

3. Wire the remote zone indicator as shown Figure 1.

4. Mount the remote zone indicator in the electrical box using

the two plain machine screws. See Figure 2.

Note: If you are surface mounting the remote zone

indicator, you must install washers (provided) between it

and the surface mount box.

5. Attach the faceplate to the remote zone indicator. Use the

two white machine screws provided with the faceplate.

Note: Remote zone indicators will not operate properly until

detected by the control panel. For more information, see the

technical reference manual listed inside the control panel door.

1 2

Installation Sheet 1
Specifications 2

Résumé du contenu

Page 1 - Installation Sheet

Page 2 - Specifications

2 / 2 P/N 3101032 • REV 02 • REB 25JAN13 Figure 1: Wiring diagram 1. All wiring is supervised and power-limited. [2] AUX power supplied by the

Commentaires sur ces manuels

Pas de commentaire

Edwards-signaling FSRZI-A-SA Remote Zone Indicators Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Sécurité Edwards-signaling FSRZI-A-SA Remote Zone Indicators. Edwards Signaling FSRZI-A-SA Remote Zone Indicators User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Edwards-signaling FSRZI-A-SA Remote Zone Indicators