Edwards-signaling SA-ETH Ethernet Interface Card Manuel d'utilisateur télécharger pdf

SA-ETH Ethernet Interface Card

Installation Sheet

EN FR

EN: Installation Sheet

Operation

The SA-ETH card provides a standard 10/100 Base-T Ethernet

network connection for connecting to a local network. The card

can be used for uploading and downloading panel

configuration, history, and current status to a PC running the

configuration utility or connect to a compatible central

monitoring station receiver over a network.

Installation

The Ethernet card is installed on the plastic assembly and

connects to the main circuit board via a ribbon cable.

Note: The Ethernet card must be configured through

programming for proper operation.

To install the Ethernet card:

1. Power down the panel and disconnect the batteries.

2. Locate the card slot on the plastic assembly behind the

main circuit board and connector J1 on the main circuit

board (at the top-right of the main board).

3. Slide the card into the slot on the plastic assembly as

show in the diagram.

4. Attach the card to the plastic assembly using two #6

plastite screws as show in the diagram.

5. Connect the ribbon cable (P/N 7140189) from the card to

connector J1 on the main circuit board. J1 is located on

the top-right of the main circuit board.

6. Connect the network cable. See “Wiring.”

7. Power up the panel and connect the batteries.

Figure 1: Slide the card into its slot

Ethernet card

Top-right of main

circuit board

Card slot on

plastic assembly

Figure 2: Screw the card in place and connect the ribbon cable

To connector J1 on

main circuit board

(top-right of board)

Ribbon cable

#6 plastite

screws

1 2 3 4

Résumé du contenu

Page 1 - Installation Sheet

Page 2 - (PC, router, switch, etc.)

2 / 4 P/N 3101100 • REV 03 • REB 25JAN13 Wiring Note: A crossover cable or a straight through cable can be used. Figure 3: SA-ETH wiring Network ca

Page 3 - DEL 3 (duplex)

P/N 3101100 • REV 03 • REB 25JAN13 3 / 4 5. Branchez le câble ruban (P/N 7140189) de la carte au connecteur J1 de la carte de circuits imprimés pr

Page 4 - Fiche technique

4 / 4 P/N 3101100 • REV 03 • REB 25JAN13 Fiche technique Ethernet 10/100 Base-T Mode de connexion Négociation automatique Tension de service 24

Commentaires sur ces manuels

Pas de commentaire

Edwards-signaling SA-ETH Ethernet Interface Card Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Sécurité Edwards-signaling SA-ETH Ethernet Interface Card. Edwards Signaling SA-ETH Ethernet Interface Card Manuel d'utilisation Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Edwards-signaling SA-ETH Ethernet Interface Card